UNCO Smoker Gasket - 15 Ft, 1/2"X1/8", High Temp Grill & BBQ Gasket

If you have a smoker and are losing smoke around your lid this is a must have works very well and easy to install. Good quality.

I used this gasket on my Kamado Joe Grill Control Tower. The factory gasket was allowing the control tower to move around, so I put these on in 2024 to tighten up the seal. It stopped the movement. It's now 1/2 way through the 2025 grilling season and it's held up well. No smoke leaking from the gasket. However, the fit is no longer as tight, and the control tower can move slightly. It's not a deal breaker, as I can just apply new gasket as there is lots of extra.

Not one to normally write reviews.Great product that solves the air leaks on my weber kettle grill.Everyone complaining about removing the adhesive backing has never had to find the end of a roll of packing tape. It's not that difficult. However, you have to be careful since if you try to separate incorrectly, the felt will come apart.Thoroughly cleaned the surface it was going to be installed on and proceeded to attach it, removing 2 to 3 inches of backing at a time and adhering it since I was installing it on a curved surface. After making it all the way around, I ran my finger all the way around, ensuring it was pressed down the whole way around. Taking a star off because the felt started to pull apart while running my finger across it although I figure it will be fine once some smoke works its way into the felt.Smoked some ribs right after and fire management was soooo much easier! Barely a wisp or two of smoke escaped from the lids edge.More than enough left after installing on a 22 inch weber kettle.

Used this on a Traeger Pro 20. Placed it on the underside of the door instead of on the barrel. This tape is very sticky, you only get one shot because you have to destroy it to remove any mistake. This also makes removing the tape backing a little bit of a challenge. Makes your smoker door close quietly like a bank vault and zero smoke leakage. Instantly, temp control is very stable. On the Traeger, I placed it flush with edge of door all the way around and got a perfect seal. This isn’t the highest temp gasket you can buy, neither is the Traeger the hottest grill you can buy. The heat range of this gasket is well beyond the ability of the Traeger.

Amazing buy! Totally changed the smoker, keeps way more smoke inside

A++ Seal - Works Amazing - Easy To Apply And Perfect For My Pit Boss

The product does adhere to the grill, but is somewhat thin on the felt area. I was hoping for a wider piece. On the effectiveness, the gasket did handle the heat, but didn’t do a lot for the smoke loss, but this may be due to the type of gap in my grill hood. I think a solid, braided gasket is likely what I need. The product isn’t bad, just not the most effective. It was inexpensive, so I do think there is value there for minor fixes, but I don’t have a lot of hope for the longevity of the product.

I have to say that they must have had my smoker in mind when they decided the length because I had the EXACT amount I needed. This stuff works very well and I'm able to get a finer adjustment on my temps.