Araldite Standard 2-Part Epoxy Syringe, 24ml. Strong, Multipurpose, Solvent-Free Adhesive Ideal as Ceramic Glue, Plastic Glue, Metal Glue, Jewellery Glue & Glass Glue. For Durable Bonding & Repairs

Great product

It's been my go-to epoxy for many years, it works perfectly every time and I can absolutely depend on it.It doesn't set quickly, so that makes it really good because it's not a race against time to get the glue where you need it before it goes off, or, to remove glue where its ended up in exactly the place that you definitely didn't;t need it!The syringe dispenser makes it really easy to use, when I first used araldite it was in separate tubes, which is ok, but it's far more messy and you have to ensure you dispense the same proportion of both parts, it comes with a stick to mix it, but I just use tea/coffee stirrers, you only need to mix it for 30 seconds and you can tell when it's mixed when you cannot see any streaks in the resin.I use my stirrer to apply the glue, in my pictures I filled a void in a 3D printed part, although the epoxy is quite a "stiff" glue, it will fill gaps as it levels itself, this allowed the epoxy to fill around my "joint" piece which connected both haves, I placed my part face down on glossy card.You need to clamp your pieces to hold everything in place while it sets, you definitely don't want it setting with pieces in the wrong place because they're not coming apart ever, I use some cheap clamps and they work great.You can see on the front that the epoxy levelled and filled in the tiny gaps, resulting in everything being bonded incredibly well, you would break the bits that weren't glued before you had anywhere near any issue with the glued section.I left it clamped for 8 hours, after which I removed the clamps and then let it sit overnight, the following morning it lifted straight from the glossy paper and revealed a very clean joint. As this part is going to be painted, I used a coarse grit sandpaper to gently and methodically work over the surface until it was level with the printed parts, at that point I worked up in various grits to 3000, after which the area where the joint and glue was smooth and flat and you are unable to feel any difference in the surface between the printed parts and this joint section, it's completely merged into the whole part.It really is one of the best glues around.

Good bond when set would definitely buy this product again

Really easy to use. The glue is fantastic for sticking soles of shoes. Our Grandson has a tendency to drag his feet. Saves buying a new pair of £40.00 shoes. Dries very clear.

Araldite is my go to product if I have a particularly sensitive job to do, always a reliable and durable product and I've had mixed results with alternatives. However, this latest mixing tube design seems absolutely bonkers on a product that is only 24ml in the first place. The volume of the mixing tube is likely more than I need for the small jobs, it's going to be very wasteful. I see there may be a pack of nozzles available from Araldite in future but by then I think I would have found an alternative product. I pay the premium for Araldite but I feel I'm going to be wasteful and will revert back to mixing by hand which will be messy with this particular product's packaging and dispensing design.I urge Araldite to think again. Why did you choose this product over others?:Reliable and durable product

Used this for fixing scalextric cars was so much better than other glues.

Excellent product. Be patient it takes a little while to glue.

I feel like this used to set faster. It seems to take about 8 hours but i remember in the past it was more like 30 minutes, which was sometimes very useful. Due to the design of the dispencer its sometimes difficult to get a 50/50 ratio but even when I make sure to do this, the cure time is long